The letters and logos are made with either
router cut or waterjet cut machinary.
Router cut letters and logos
are mechanically routed out of flat metal stock. Based on
the material thickness and letter size, a 1/8"-1/4"
router bit will be used. As a result, inside corners will
have a slight radius.
Waterjet cut letters and logos
are made using a fine, high pressure stream of water that
carries an abrasive mineral. This fine stream cuts and allows
for sharp (.060") inside corners, intricate detail
on logos, and letters under 2" high.
Both methods of cutting allow the same surface
finishes after being cut.
Finishes:
Flat
cut metal letters and logos are available in Aluminum, Bronze,
Brass, Copper, Stainless Steel and Hot Rolled Steel in many
thicknesses and finishes.
